Karcher IVC 60-30 Tact - Manual (Page 17)

– 5
 Empty the container.
 Check whether the protective cover is
available and the side opening of the
protective cover points to the right
placement mechanics (see illustration
of appliance).
 Clean the thermal probe and the protec-
tive cover with a moist cloth.
 Turn the appliance off and back on.
 Clean the thermal probe and the protec-
tive cover with a moist cloth.
 Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
 Check the suction head and the recep-
tacle for proper seating.
 Replace the flat pleated filter.
 Lock the filter cover.
 Check the proper installation position of
the flat fold filters.
 Replace the flat pleated filter.
 Clean the thermal probe and the protec-
tive cover with a moist cloth.
 Suction hose is not connected.
 Suction hose used is too short (< 3m) or
the diameter is too large.
 Inform Customer Service
 Inform Customer Service
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
– Only use accessories and spare parts
which have been approved by the man-
ufacturer. The exclusive use of original
accessories and original spare parts
ensures that the appliance can be oper-
ated safely and trouble free.
– At the end of the operating instructions
you will find a selected list of spare parts
that are often required.
– For additional information about spare
parts, please go to the Service section
at www.kaercher.com.
– Accessories are not included in the de-
livery. The accessories for the device
must be ordered separately, depending
on the application.
– The proper functioning of the unit is only
ensured when a suction hose of a nom-
inal width of DN42 or DN52 is used.
– You can procure the spare parts and
the attachments from your dealer or
your KÄRCHER branch office.
Suction turbine turns off
Suction turbine does not start again
after the container has been
emptied
Suction capacity decreases
Dust comes out while vacuuming
Automatic shut-off (wet vacuum
cleaning) does not react
Automatic filter cleaning is not
working
Automatic filter cleaning cannot be
switched off
Warranty
Accessories and Spare Parts
17 EN