Karcher BDP 50-1500C - Manual (Page 2)

Operating Instructions English
5
Intended use
The spray bottle is used to apply
cleaning agents.
Safety notes
Note:
The spray bottle is composed of
various materials, which react
differently to cleaning agents so
that the spray bottle can be
damaged if it is used improperly.
Only use liquid and water-
soluble agents.
—
The nozzle can become
clogged if viscous mixtures are
used.
If acidic or solvent-containing
agents are used care must be
taken to ensure they are
compatible with the materials
comprising the spray bottle.
Warning!
Strictly comply with the
recommendations given in the
product information sheet, the EU
safety data sheet and on the label
of the cleaning agent bottle.
—
The regulations for the
operation and cleaning of the
spray bottles must be complied
with.
—
Never subject the spray bottle
to pressure when it is empty.
—
Never use damaged or not
properly functioning spray
bottles.
—
Never spray it near food,
humans or animals.
—
Immediately consult a doctor if
cleaning agents get in eyes or if
they cause health problems (for
example, a headache, nausea
or dizziness).
—
Always wear suitable protective
clothing when using cleaning
agents.
—
The temperature of the filled-in
cleaning agent may not exceed
40°C. The materials used to
make the spray bottle are not
suitable for higher
temperatures.
—
Never direct the nozzle at
yourself or others, since líquid
can accidentaly escape.
—
Never blow out parts with your
mouth.
—
Do not expose the spray bottle
to solar radiation and/or other
sources of heat.
—
Operate the spray bottle only
with the unit’s own pump and
never connect it to a
compressor, a condenser or
anything similar.
—
Only use genuine spare parts.
—
Repairing the bottle is not
permissible.
—
Check the spray bottle for
ageing and wear after 5 years
of use. Replace it, if necessary.
Initial operation of the
spray bottle
Make certain that the spray
bottle is unpressurized by
actuating the spray lever.
Warning!
Cleaning agent will be sprayed out
of the nozzle if the spray bottle still
contains residue pressure.
For safety reasons hold a suitable
container beneath the nozzle.
Unscrew the bottle from the
spray unit.
Fill the bottle with water and
cleaning agent.
Warning!
The bottle may only be filled with a
maximum of 1 litres of liquid.
Measure dosage of the cleaning
agent and its concentration
according to specifications.
Pressurize the spray bottle with a
maximum of 15 pumping actions.