Karcher BR 40-10C ADV - Manual (Page 2)

QUICKSTART
5.964-029.0 11/12
Operation
1 A Adjust the brush contact pressure
A Place the slider vertically.
Pull out the rotary handle of the brush contact
pressure and set it to the desired value.
Note
Carry out the initial cleaning attempts with less
contact pressure. Increase contact pressure
step-by-step until the desired cleaning result is
achieved. The correct setting of the contact pres-
sure reduces the wear and tear of the brushes.
The brush drive is switched off when there is
overload.
When cleaning with microfibre rollers, the contact
pressure must not be adjusted higher than the
position mentioned below. With a higher contact
pressure, there is a danger of destroying the mi-
crofibre rollers.
2 A
D
B C Cleaning
ƽ Danger
Risk of injury on account of electric shock caused
by a damaged mains cable. Do not let the mains
cable come in contact with the rotating brushes or
pads.
Caution
Risk of damage. When cleaning close to a wall,
position the appliance so that the deflection
rollers point towards the wall.
A
If the detergent solution is to be vacuumed off
after the cleaning process:
Check that all vacuum bars are inserted into
the appliance
B Press the pedal to lower the vacuum bar.
Place the slider vertically.
C Turn on the brush irrigation by using the
switch for the detergent solution.
Turn on the brushes by using the switch for
the brush drive.
D Swivel the slider toward the operator - the
chassis is retracted and the brushes touch
the floor.
Move the appliance over the surface to be
processed by the slider.
Caution
Risk of damage to the floor covering.
Do not operate the appliance on the spot.
3 A B Polishing
A Press the push-button for the vacuum bar
change toward the inside - the vacuum bar
will release.
Remove both vacuum bars from the appli-
ance.
Place the slider vertically.
B Turn on the brushes by using the switch for
the brush drive.
Swivel the slider toward the operator - the
chassis is retracted and the brushes touch
the floor.
Move the appliance over the surface to be
processed by the slider.
Caution
Risk of damage to the floor covering.
Do not operate the appliance on the spot.
Note
To polish underneath furniture, the fresh water
and wastewater reservoirs can be removed.