Karcher SDP 9500 - Manual (Page 16)

– 8
The liquid level must at least be 3 cm (SCP
9000) and 8 cm (SDP 79500) for the pump
to suck in liquids independently.
Î
Insert the mains plug into the socket.
In the automatic mode, the level switch au-
tomatically controls the pumping opera-
tions. The pump switches on or off when
the fluid level reaches the height that has
been set.
Ensure that the level sensor is not obstruct-
ed in any way.
In manual opertions the pump remains
switched on continuously.
Note:
Dry run leads to increased wear and tear;
do not leave the pump unattended when it
is running. Switch off the pump within 3
minutes of dry running.
In flat suction mode, fluids can be sucked
out till the height of the remaining liquid is 1
mm. For this, the device needs to be oper-
ated manually.
Î
Fold in the folding feet
Î When the height of the remaining fluid
is less than 20 mm, press the deaera-
tion key or plug in and disconnect the
pump many times till the fluid is sucked
in.
Î Disconnect the main plug from the
socket.
ƽ
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Note:
Contaminations can accumulate and lead
to malfunctions.
Î
Rinse the pump with clean water after
use.
The appliance is maintenance-free.
Caution
In order to prevent accidents or injuries,
keep in mind the weight of the appliance
during transport (see Specifications).
Î Lift appliance by the carrying handle
and carry it.
Î Secure the appliance against shifting
and tipping over.
Caution
In order to prevent accidents or injuries,
keep in mind the weight of the appliance
when selecting a storage location for it (see
Specifications).
Î Store the appliance in a frost free area.
Operation
Automatic operation
Manual operation
Flat suction (only SCP 9000)
Finish operation
Maintenance and Care
Care
Maintenance
Transport
When transporting by hand
When transporting in vehicles
Storage
Storing the Appliance
16 EN