Karcher DE 4002 EU - Manual (Page 19)

– 7
Note
The higher the temperature setting, the dry-
er and more invisible the steam; however,
the steam volume remains the same.
– Push the switch for steam ironing to the
front: Steam will escape continuously.
– Push the switch for steam ironing to the
rear: Steam push emitted.
 First, direct the steam gun at a separate
piece of cloth until no more water is
emitted.
 Set the steam quantity controller on the ap-
pliance to the desired quantity of steam.
You can hold the iron in an upright position
to apply steam to curtains, dresses, etc.
 Ironing without steam: Switch on the
appliance and switch off the the heating
switch.
 Set the temperature controller on the
iron to the desired fabric.
Order no. 4.130-145.0

Apply steam to the glass surface from a
distance of approximately 20 cm until
the surface is moistened evenly.
 Switch off the steam supply.
 Strip the glass surface in straight lines
from the top to the bottom using the rub-
ber lip.
 Wipe the rubber lip and the bottom
edge of the window dry after each strip.
Order no. 2.863-076.0
You can use the wallpaper remover with
the steam cleaner to remove wallpapers.

Apply wallpaper remover to the edge of
a wallpaper length and let the steam
settle in until the wallpaper is fully mois-
tened (approx. 10 seconds).
 Reset wallpaper remover without
switching off. Lift the soaked piece of
wallpaper using a flat trowel, and pull it
off the wall.
In case of woodchip wallpaper that has
been painted several times, the steam may
not be able to soak the wallpaper. If this
happens, you need to prepare accordingly
with a nail roller.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
When working with extension pipes and the
floor nozzle the appliance can be transport-
ed easily, e.g. up and down steps.

Switch off the heating at the switch.
 Place the appliance vertically.
 Hook the extension pipe with the holder
to the bottom side of the appliance.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
 Place the manual nozzle, detail nozzles
and small parts into the accessories
storage box.
 Wrap the cable around the holder on
the floor of the appliance. Insert the ex-
tension pipes individually into the re-
cesses on the appliance floor.
Note
Always allow the brushes to cool down for
a sufficient period of time to avoid a defor-
mation of the bristles.
Dry ironing
Man-made fi-
bre Wool Linen
Window nozzle (option)
Wallpaper remover (optional)
Transport
Transporting the device
Storing the device
Storing the Appliance
19 EN