Karcher BP 1 Barrel Set - Manual (Page 16)

– 4
Caution
Create stability for the appliance
prior to all work on or with the
appliance to prevent accidents
or damage.
The stability of the appliance is war-
ranted when it is placed onto an even
surface.
1 Power cord with plug
2 Drum edge holder
3 Locking valve
4 O ring
5 Housing bowl for level switch
6 Housing cover for level switch
7 Hose coupling
8 Pressure hose
9 Hose clamp
10 Level sensor
11 Level switch attachment
12 Carrying handle
13 Hose connection G
3 /
4
(24.4 mm)
for hose coupling
 Screw the hose connection on to
the pump
 Connect the hose connection to the
hose coupling of the drum edge
holder.
Illustration
 Screw the housing bowl and the O-
ring onto the drum edge holder.
 Place the level switch into the hous-
ing bowl.
 Press the housing cover down onto
the housing bowl until it locks.
Illustration
 Slide the drum edge holder onto the
container edge until it is properly
seated.
Illustration
 Place the pump on a stabil surface
in the liquid to be transported. Im-
merse it using a rope tied to the
handle or hang it into the container
by the hose.
The suction area should not be
blocked fully or partially through the
impurities.
Illustration
 Close locking tap (arrow horizontal).
Illustration
 In automatic operation, set the re-
quired switching height by clamping
the level switch cable into the stop-
per.
Illustration
 In manual operations mode, align
the level sensor upward (cable
pointing downward). Tip: Push the
cable of the level sensor like a loop
through the handle.
Prerequisites for the
appliance's stability
Operation
Description of the Appliance
Preparing the drum pump
operation
Different uses of the level
switch
16 EN