Karcher HD 13-35 Pe - Manual (Page 4)

English
- 1
Please read and comply with
these original instructions prior
to the initial operation of your appliance and
store them for later use or subsequent own-
ers.
ƽ Danger!
Risk of injury due to defective appliance.
Check the faultless condition of the appli-
ance before using it. The appliance is not
fit for use if it is not in a faultless condition.
The appliance may not be modified.
Please observe the safety instructions of
your high-pressure cleaner.
The nozzle is intended for use with high
pressure cleaners
The water pressure indicated on the out-
side of the nozzle must not be exceeded.
 When opening the hand spray gun,
point the spray lance with the nozzle
downward to prevent wear on the noz-
zle.
 Begin the cleaning work with a nozzle
distance of 20 to 30 cm.
Determine the most favourable nozzle
distance by slowing approaching the
cleaning object.
 Protect the nozzle from contamination
during work breaks - do not leave it in
the water.
 After your work is done, clean the noz-
zle on the inside and outside, dry and
grease it.
 Store the nozzle in a dry place.
Maintenance tasks are required for:
– uneven or no rotation
– poor spray pattern
 Clean the outside of the nozzle.
 Unscrew both threaded pins until about
2 thread lines protrude from the nozzle
casing.
 Point the nozzle downward and open
the casing (key width 27).
 Remove the rotor.
 Press the seat out using special tools
(part no. 6.025-233.0).
 Place the new seat on top of the special
tool.
The tapered recess of the seat must
point toward the handle of the special
tool.
 Grease the seat using silicone grease
(part no. 6.288-044.0).
 Press the seat into the nozzle casing,
do not pound in.
 Carefully insert the rotor into the nozzle
casing and align with the seat.
 Grease the thread on the drive cover
with grease (part no. 6.288-079.0).
 Point the nozzle downward, align the
rotor in the seat and screw the drive
cover in fingertight.
 Tighten the threaded pins.
Safety instructions
Proper use
Operation
Maintenance
Install repair kit, replace seat
4 EN