Karcher BRC 30-15 C - Manual (Page 12)

– 3
 Vacuum loose dirt with a vacuum clean-
er prior to cleaning.
 Swivel the pushing handle lock to the
outside, set the desired pushing handle
height and close the lock.
 Insert the mains plug into the socket.
Caution
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
ƽ
Danger
Risk of electric shock.
Do not let the mains cable come in contact
with the rotating brushes or rotating pads.

Set the appliance switch to normal op-
eration - start the suction turbine and
the brush drive.
 Use the detergent solution key on the
push bow to spray on detergent solu-
tion.
 Run across the surface to be cleaned in
overlapping paths. Pull the appliance
backwards during this procedure (do
not push).
 If the waste water reservoir is filled to 3/
4 of its capacity, switch the appliance
switch to "OFF".
 Swivel the domelock to the front.
 Lift the waste water reservoir off the ap-
pliance and empty it.
ṇ
Warning
Please observe the local provisions regard-
ing the wastewater treatment.
Note
If the waste water reservoir is full, dirty wa-
ter will flow back onto the carpet, as soon
as the appliance is switched off.
Only use accessories and spare parts
which have been approved by the manu-
facturer. The exclusive use of original ac-
cessories and original spare parts ensures
that the appliance can be operated safely
and trouble free.
 Connect the provided adapter to the de-
tergent hose of the accessory tools.
 Pull the suction hose out of the dome.
 Insert the suction hose of the accessory
tool into the dome instead of the suction
hose.
 Connect the coupling of the detergent
hose on the appliance to the detergent
hose of the accessory tool.
 Set the appliance switch to operation
with manual nozzle - the suction turbine
will start.
 Use the lever on the accessory tool to
spray on detergent solution.
Important
When unplugging the accessory tools, the
adapter must be removed from the appli-
ance, so that the water output on the appli-
ance is closed.
Recommendation: Leave the adapter on
the hose of the accessory tool.
Operation
Emptying the Dirt Water Reservoir
Operation with accessory tools
12 EN