Karcher G 7-10 M - Manual (Page 17)

– 6
ṇ
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the trigger gun and spray lance
firmly.

Unlock the lever on the trigger gun.
 Pull on the lever of the trigger gun; the
device will switch on.
Carrying out the most common cleaning
tasks. The work pressure can be stageless-
ly regulated between "Min" and "Max".

Release the lever on the trigger gun.
 Turn the spray lance to the desired po-
sition.
For particularly dirty items or areas.
Not suitable for use with detergents.
Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were
specifically developed for your appliance.
The use of other detergents and care prod-
ucts may lead to premature wear and can
invalidate your warranty claims. Please ob-
tain information at your local dealer or re-
quest information directly from KÄRCHER.

Use spray lance with pressure regula-
tion (Vario Power).
 Turn the spray lance to "Mix" position.
Note: This will mix the detergent with
the water stream.
 Adjust the suction volume of the deter-
gent solution at the detergent filter.
- Medium quantity: Central position
- Large quantity: "+" position
- Small quantity: "-" position
 Suspend end of detergent suction hose
in a container filled with detergent.
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high-
pressure jet.
 Release the lever on the trigger gun.
Note:When the lever of the hand spray
gun is released, the engine continues to
run at zero speed. The water thus circu-
lates within the pump and gets heated.
When the water has reached the maxi-
mum permissible temperature (60°C),
the themostat valve opens and water
flows out.
 Lock the lever on the trigger gun.
 Insert the trigger gun in its holder.
 During longer breaks (more than 5 min-
utes), also turn off the motor.
Caution
Only separate the high-pressure hose from
the trigger gun or the appliance while there
is no pressure in the system.

After working with detergent, suspend
detergent suction hose in a container
filled with clear water, switch the appli-
ance on for around 1 minute once the
spray lance has been removed and
rinse until water runs clear.
 Release the lever on the trigger gun.
 Stop the motor.
See Operating Instructions of motor.
 Turn off tap.
 Press the lever on the trigger gun to re-
lease any remaining pressure in the
system.
 Detach the appliance from the water
supply.
 Lock the lever on the trigger gun.
 Insert the trigger gun in its holder.
 Suspend the high-pressure hose into its
holder.
Operation
Spray lance with pressure regulation
Spray lance with Dirtblaster
Working with detergent
Recommended cleaning method
Interrupting operation
Finish operation
17 EN