Arcam P38 - Manual (Page 11)

e-11
english
adjusting listening settings
The A38 allows you to customise various features of the
amplifier to fit your system. Use this diagram to help you
navigate through the available configuration options.
In the diagram, the control knob is shown as
.
Normally, the display shows the current volume and the
control knob is used to adjust this.
Press
MEnu once to enter the setup menu, then press
oK repeatedly to cycle through the menu items. When
A38 setup
you have found the setting that you wish to adjust (as
shown on the front panel display), you can change the
setting using the control knob. Press MEnu to store the
change and return to volume display mode – or press
oK again to move to the next setting.
Note that the menu will time-out after a short period
without pressing a button, with the display reverting to
the current volume.
The following items can be adjusted from the setup
menu:
configuring your A38 amplifier
Balance This allows you to adjust the output balance between left and right channels. The display is
also available directly by pressing the front panel dIsPLAy button.
Volume resolution There are three volume-display options to chose from: ‘Standard’, ‘Fine’ or ‘Reference’.
Standard and Fine represent different levels of volume-control sensitivity; the Reference
setting gives absolute increments in 0.5dB steps.
Input trims Input trims are used to compensate for variations in output levels of different source
equipment. If, for example, your CD player is louder at a given volume display value
than other inputs, you can attenuate it by using this setting so that it matches your other
components.
Use the source-select buttons to select the input you wish to adjust, then the control knob
to set (increase or decrease) the input volume for that source.
Max on volume This can be used to limit the maximum volume the amplifier operates at when it is first
switched on: the A38 comes on at the (reduced) ‘Max. On Volume’ level if the last-used
volume exceeds this value.
If this item is set to ‘Disabled’, the A38 always comes on at the last used volume, even if this
is very loud.
Processor mode Processor mode enables you to fix the gain (volume setting) of your A38. The A38 (in
combination with a power amp.) can then be used to drive the front left and right speakers
of a surround-sound system, when fed from a separate processor. The volume of the entire
system can then be controlled using the processor.
Feed the sound from the processor into the
AV input, then set the gain of the A38 to match
the amplifiers that drive your other loudspeakers.
Reset Confirming ‘Yes’ restores all amplifier settings to their factory defaults.
‘Power On’ state