Arcam AV8 PReamp Processor E-2 - Manual (Page 18)

E-18
E-18
E-19
E
n
g
li
sh
Remote control
SELECT DEVICE
SET
LAST
SLEEP
A–B
EXIT GUIDE
CH VOL
MUTE 0
FM
8
AV
9
MCH
7
TUN
5
AUX
6
TAPE
4
CD
2
SAT
3
VCR
1
DVD
THX
FX
SUB
P.MODE SUBT TITLE MENU
ZOOM AUDIO MEM RETURN
ANGLE SETUP STATUS SEARCH
DIS TRM 1 2
TST SYN DYN SLP
P – P + TM FAV
MODE OPEN
MENU INFO
CR80
DVD CBL VCR TV
SAT CD AMP AUX
OK
AM
NOTE
Remember to correctly install the two AA batteries supplied
before trying to use your remote control.
The CR80 remote control is a multi-function unit that controls the AV8
and up to seven other devices. The instructions on this page only refer
to the control of the Arcam FMJ AV8.
For information on using the remote control for other devices, and a
full list of features, see the instruction booklet supplied with the CR80.
SYN (Lip sync)
Press once to adjust the Lip sync audio delay. Use
the
3 and 4 navigation buttons.
Press again to exit the Lip sync function.
TRM (Speaker trim)
Press to display the OSD Speaker trim level menu.
TRM allows temporary adjustment of speaker
levels, using the navigation buttons. Press again to
exit the ‘Speaker Trim’ function.
Source selection
DVD – DVD input
SAT – Satellite input
VCR – Video Cassette Recorder input
CD – Compact Disc player input
AUX – Auxillary (line) input
TAPE – Tape (monitor) input
TUN – Tuner input
AV – AV input
MCH – DVD-A (multichannel) input
Press the relevant button once to select input; press
and hold to select the analogue input if a digital input
is present.
MUTE
Press once to mute the main system. Press again (or
use
VOL +/– ) to un-mute.
MODE
Use this button to cycle through available surround
modes.
INFO
Press once to display the OSD report on source
inputs and processing mode.
DIS (Display)
Press to cycle through Off/Dim/Bright illumination
of the front panel display
Device selection
IMPORTANT: Press the ‘AMP’ button first to
operate the AV8.
On/Standby
This allows the AV8 to be put into and taken out of
standby remotely.
Navigation buttons
Arrow buttons allow navigation around the menus
on the AV8.
Confirm selection by pressing OK . Press and hold
the OK button to swap PAL/NTSC OSD modes.
MENU
Press to select the OSD Main menu.
Press and hold for more than two seconds to
select the ‘Setup Menu Index’.
FAV (Favourite)
Use this button to clear any temporary
adjustments and return to the current preset
settings.
SUB (Subwoofer trim)
Allows a temporary trim of the subwoofer level.
Press
SUB , then adjust using the 34 buttons on
the navigation panel.
THX (THX mode)
Use this button to cycle through available THX
modes.
VOLUME +/–
Adjusts the volume.
FX (DSP effects mode)
Use this button to cycle through effects modes for
two-channel sources.
The other buttons in this area are used for DVD
and Tuner control and do not effect the AV8.