Platinum – Haltech Platinum PRO PLUG-IN Nissan Skyline R32 / R33 (HT055001) User Manual
Page 3
Appendix A
For this ECU to work on a RB20DET or RB25DE Engine configurations the following
wires must be swapped within your factory harness as the Injector ouputs between
the RB25DET and RB26 configurations to the RB20DET or RB25DE configurations are
different.
Please move the pin 112 (Injector 6) to position 114
Please move the pin 114 (Injector 4) to position 112
Please see below
Figure 12 – Harness connector looking at wire side
PLATINUM
Pro Plug-in Nissan Skyline R32/R33
Quick Start Guide
Congratulations on purchasing a Haltech Engine Management System.
This fully programmable Plug and Play product opens the door to virtually limitless
performance modification and tuning of your vehicle. Programmable systems allow you
to extract all the performance from your engine by delivering precisely the required
amount of fuel and ignition timing that your engine requires for maximum output under
all operating conditions.
This quick start guide will walk you through installation of the Platinum Pro ECU into
a vehicle. This guide is accompanied by the full service manual located on the software
CD provided with the ECU that you or your tuner will need to refer to before completing
your installation and configuration. The Manual is included in the software which can be
downloaded from the Haltech web
Supported Vehicles
The Platinum Pro Plug-in Nissan Skyline R32 / R33 ECU supports the following:
Nissan Skyline R32 GT-R
Nissan Skyline R32 GTS-t *
Nissan Skyline R33 GT-R
Nissan Skyline R33 GTS-t *
* WARNING!
Please note if RB20DET or RB25DE Engine configuration is to be supported you
must swap pins 112 (Inj 6) and 114 (Inj 4) on your harness. Potential damage will
occur to your engine if this is not done. Please see Appendix A.
Platinum Pro Plugin Skyline R32 / R33 Kit Includes
•
Haltech Platinum Pro Plug-in ECU
•
USB Cable
•
Software CD
•
Quick Start Guide
•
Haltech Sticker
Loaded Basemap
Your Platinum Pro Plug-in has been programmed with a basemap to suit a
Nissan R32 / R33 running a RB26DETT engine using standard MAF sensors.
Alternatively, a basemap using the Haltech ECU Internal MAP Sensor as a load
reference is available in the
C:\Users\XXXX\Documents\Haltech\ECUMaps\Nissan\R32R33 folder for you to
upload into your ECU.
Please make sure you connect the Haltech ECU Internal MAP sensor to the intake
manifold prior to starting the vehicle.
Please ensure you load, modify and check the corresponding basemap for your
application before attempting to start the vehicle.