Ferguson Ariva 220Combo - Manual (Page 45)

ATTACHMENT B – Using the universal RCU-640 version 2 remote control
Setup TV via brand name search
1. Switch on the TV for which you wish to use the remote control.
2. Point the remote control at the TV. Press and hold down the TV and POWER button for three seconds.
Then release buttons.
3. The POWER button lights up and the remote control is in set-up mode.
4. Press and hold pressed number button corresponding to to your TV brand.
All brand name start with Letter “A, B, C”, you can press and hold pressed number 2 button for quick
brand search. To find the right button just look at the letters printed on it.
For example, if TV brand is Sony, just keep pressed number button 7, the “Volume+” signal is
automatically transmitted from the remote control to the device (code scan).
5. As soon as the volume of the TV changes, immediately release number button.
6. Check whether the other buttons on the remote control function correctly. If the majority of the buttons
do not function correctly, continue searching (see steps 4 to 5).
brand name start
with number
button
A, B, C 2
D, E, F 3
G, H, I 4
J, K, L 5
M, N, O 6
P, Q, R, S 7
T,U, V 8
W, X, Y, Z 9
Setup TV via auto search
If the set up via brand name and code was not successful or you were unable to find your brand name in
the list, you can use the auto search function to find the correct TV code for your remote control.
1. Switch on the TV for which you wish to use the remote control.
2. Point the remote control at the TV. Press and hold down the the TV button for 3 seconds, (or just press TV
button for three seconds). The POWER button should lights up, i.e. the RCU640 is in Auto Search mode.
3. The VOL+ signal is automatically transmitted from the remote control to the TV (code scan). As soon as
the TV volume changes, immediately press TV button to terminate Auto Search, now the POWER button
light goes out.
4. Switch on the TV via the POWER button. Check whether the other buttons on your remote control
function correctly. If none of the buttons function (i.e. the search was not be stopped at the correct time)
or the majority of the buttons do not function correctly, restart the search (see steps 3 to 4) to find a
suitable code. If the majority of the buttons function correctly, set up has been successful. Re-press the TV
button to save the code and to terminate the set-up mode.
NOTE: Entering the auto searching mode, it will search forward from the current code.
NOTE: After all codes have been gone through, The POWER button will flash three times and go off. The
RCU640 exit from auto search automatically.
Setup TV via brand name code
45