ROTHENBERGER ROMAX Compact Schaltnetzteil 230 V - Manual (Page 8)

6 ENGLISH
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tools operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and tool
bits etc., in accordance with these
instructions and in the manner intended
for the particular type of power tool,
taking into account the working
conditions and the work to be performed.
Use of the power tool for operations different
from those intended could result in a
hazardous situation.
5) Battery tool use and care
a) Ensure the switch is in the off position
before inserting battery pack. Inserting the
battery pack into power tools that have the
switch on invites accidents.
b) Recharge only with the charger specified
by the manufacturer. A charger that is
suitable for one type of battery pack may
create a risk of fire when used with another
battery pack.
c) Use power tools only with specifically
designated battery packs. Use of any other
battery packs may create a risk of injury and
fire.
d) When battery pack is not in use, keep it
away from other metal objects like paper
clips, coins, keys, nails, screws, or other
small metal objects that can make a
connection from one terminal to another.
Shorting the battery terminals together may
cause burns or a fire.
e) Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If
contact accidentally occurs, flush with water. If
liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may
cause irritation or burns.
6) Service
Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
Special Safety instructions
Always convince yourself that the mains voltage
coincides with the details on the type plate.
Please only use certified and flawless extension
cables with a minimum cable cross section of
1.5mm²
We recommend disconnecting the device from the
mains supply after finishing work or before longer
breaks.
The device has double insulation according to EN
50144 so that an earth lead is not necessary.
The device is faulty if the LED indicator does not
illuminate or flash. Please disconnect from the
mains supply and contact the manufacturer.
The device must only be used with the symbols
that are displayed on the rating plate.