ROTHENBERGER WALL CUT 6540 User Manual

Page 17

ENGLISH

When tightening ensure that the 4 positioning pins on the handle holder are fitted in the
bores of the protective cover!

Connect the dust remover (accessory item no. FF35148) to the connecting piece (6). The

dust remover must be suitable for removing stone dust.

Please wear a protective dust

mask!!

Before switching on, place the equipment on both rear rollers

(10) so that

the cut-off wheels are able to turn freely.

3.5 Milling

Mount a wooden batten for better handling of the equipment when cutting/milling into the

walls horizontally/diagonally.

Place the equipment on the rear rollers and hold the handle down so that the cut-off wheels

can rotate freely.

Switch the equipment on as

follows:

Unlock:
Switch on:

Press the disabling button

(2)

Press the ON/OFF switch

(1) and release,

release the disabling button

(2)

Switch off: Press the ON/OFF switch and release

Lower the equipment slowly and steep into the

material

Pull equipment using moderate force,

do not push

Upon completion swivel the cut-off wheels out of the

groove and switch equipment off.

Observe adequate cooling-down breaks! The equipment must be raised after a
cutting time of approx. 2 minutes and run for a minimum of 10 seconds without being
under pressure. The great circumferential speed in connection with the construction of
the wheel causes rapid cooling of the diamond tool!

3.6 Shutting down

Please note: The cut-off wheels must not be decelerated when running down.
Always place the equipment on its side when it is running down and never on its
wheels. Only operate the spindle locking device when the equipment is at a
standstill!

When placing the equipment on its side, ensure that the cut-off wheels are not pointing

towards the body when running down.

Remove the plug from the mains supply and shut down the dust remover

3.7 Cutting out the grooves with the chisel

Cut out the milled groove using the chisel provided.
The cut depth should be set approx. 5 mm deeper than the desired depth to compensate any
inaccurateness that may arise when breaking out the centre bar.

Troubleshooting

Symptom

Possible Reason

Solution

Equipment will not start up

No power supply

Check mains supply

Switch faulty

Please contact service

Carbon brushes worn

Replace carbon brushes

Equipment vibrating badly

Wobble or radial run-out on
cut-off wheels

Replace cut-off wheels