ROTHENBERGER Universal ROTIGER VARIO Electronic User Manual

Page 16

ENGLISH

The machine is designed that the blade could

be mounted or removed without a wrench or

any other tools.
1. Press the switch and the shaft will move

forward. Then turn off the switch and unplug

the power cord.

2. Please turn the quick-release collar as

shown.

3. Turn the quick-release collar to insert the

blade into the small slot of the shaft. The

blade could be mounted either in the upward

or downward direction. When you release the

quick-release collar, the spring will return

automatically.

4. Pull the blade forth and back for several

times by hand to ensure the blade clicks.

5. Sometimes you need to turn the quick-

release collar as shown to ensure the blade

is mounted appropriately when there is dust

or dirt accumulated on the quick-release

collar.

Removing the blade

WARNING: Make sure to unplug the power

cord when mounting or removing the blade.

Press the switch and the shaft will move

forward. Then turn off the switch and

unplug the power cord.

Turn the quick-release collar as shown.

WARNING: Never touch the blade with bare

hands after cutting. The blade is often very

hot after cutting and may result in personal

injury.

WARNING: Never use the saw if the fixing slot

of the tip of the blade is damaged.

When the blade is broken If the blade is broken

and remains in the shaft, turn the quick-release

collar and the broken part will fall out. If not, use

a tip of another blade to take it out.

Use compressed air to clean the accumulated

chips on the quick-release collar.

Lubricate the quick-release collar regularly to

prevent from rusting.

WARNING: NEVER TOUCH BLADE

IMMEDIATELY AFTER USE, AS IT MAY BE

HOT ENOUGH TO CAUSE SEVERE BURNS.

TO PREVENT ACCIDENTAL ELECTRICAL

SHOCK THE SAW MUST BE HELD WITH ONE

HAND ON THE MAIN HANDLE AND THE

OTHER HAND ON THE RUBBER GEARCASE

COVER. THE RUBBER GEARCASE COVER

MUST BE FREE OF DAMAGE AND

PROPERLY INSTALLED AT ALL TIMES.

Adjusting the shoe plate

If some of the teeth of the saw blade is worn out,

use a hex wrench to adjust the position of the

shoe plate. Tighten the screw after the

adjustment.

TO START AND STOP SAW

Make sure power circuit voltage is the

same as shown on the specification plate

on the saw. Connect saw to power circuit.

Hold saw firmly. Squeeze trigger switch to

start motor.

Release trigger to stop motor.

D-Handle Models only:

D-handle models also have a Lock Button. To

lock the switch in the on position, press the lock

button while the switch is fully on. To release the

lock, press the switch and release it.