AeroGarden 6 Elite 100633-DSS - Manual (Page 12)

24-Hour
Light
Water Low Add Nutrients
Replace
Bulbs
Salad
Greens
Flowers
Vegetables Live Plants
Herbs
AeroGarden 6 Elite+ control Panel
Basic Reminders About Your AeroGarden
• Remove Bio-domes
When plants appear through hole in
Seed Pod Label, remove Bio-Dome
and discard or recycle.
noTe: never remove Seed Pod Labels.
11
• Water Low
When light blinks
add water up to
“Fill To Here.”
• Add Nutrients
(Feed Garden - Basic Feeding)
When “Add Nutrients” and “Water
Low” lights start blinking (every 2
weeks), add 2 nutrient tablets* and
fill the Bowl with water up to “Fill
to Here.” Press and release “Reset”
button to restart nutrient timer and
turn off blinking lights.
*See Tending & Harvesting Guide for
plant-specific nutrient information.
• Replace Bulbs †
When light blinks (after 6 months of use), it
is time to replace Grow Bulbs. Order bulbs
at www.aerogardensupport.com or from
your retailer. After replacing Grow Bulbs,
press “Reset” button to restart grow bulb
timer and turn off flashing light.
noTe: If you store your AeroGarden 6 elite+ be-
tween uses, grow bulb timer automatically
stops when Garden is unplugged.
†See complete replacement instructions on next page.
• Lights On/Off
Use to occasionally override built-in light timer. Once pushed,
lights will stay off/on until the next time built-in light timer is set
to go on/off. This will not affect the timing of your light cycle,
and occasional use of this feature will not harm your plants.
• Select
The number of hours the lights are on
and off depends on which plant type is
selected. Use “Select” button to reach
“24-hour Light” setting (see page 9).