Indesit NCAA-55 - Manual (Page 13)

GB
13
DOOR REVERSAL
Warning: Before attempting to remove the doors, switch off the electrical supply and pull out the mains plug.
It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated
containers whilst carrying out this operation.
You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original
packaging).
Remove the doors
1. Lay down the appliance on its back.
2. Unscrew, remove and retain
the bottom hinge.
3. Slightly open the bottom door
and slide downward remove
and carefully place to one
side
4. Remove centre hinge and
spacer if fitted. Slightly
open the top door and slide
downwards, remove and
carefully place to one side.
5. The pin will be removed and
fixed to the opposite side.”
6. Use a thin blunt instrument to
remove the top and bottom
hinge bushes and blanking
plugs from the doors, take
care not to mark the door
handle. Reposition the
blanking plugs and bushes on
the opposite side.
7. Fit the blanking plugs provided into the right hand two centre hinge holes.
8. Before changing hinge place from right side to left side, screw on left side panel should be disassemblied and after
changing hinge place, screw should be assemblied on right side panel.
Replacing the doors
1. Slide the top door upwards and locate the top hinge pin into the door brush. Reposition the centre hinge on the
opposite side.
2. Carefully slide bottom door upward
into the centre hinge pin.
3. Unscrew the bottom hinge pin and
refit it on the opposite side..
4. Fit the bottom hinge making sure
that the door is aligned to the
cabinet.
5. Carefully stand the appliance
upright in it’s required location and
make sure it is sitting level on the
floor. Open and close the doors
checking that the gasket makes a
good seal without any gaps when
the doors are closed.
Note: Replace loose items/fittings
back into the appliance and leave for
at least 15 minutes before switching
back on.