beautypg.com

ADT Security Services PowerSeries SCW9047-433 User Manual

Page 10

background image

6

To select a Bypass Group when arming the system:

1. Press

, then your [access code] (if necessary).

2. Press

. The next time the system is armed, the zones in this group will be bypassed.

3. To exit bypassing mode and return to the Ready state, press

.

NOTE: A Bypass Group is only recalled if the system is armed/disarmed after programming the by-
pass group.
NOTE: This feature is not to be used in UL Listed installations.

Trouble Conditions

When a trouble condition is detected, the Trouble ( ) indicator will turn on, and the keypad will
beep every 10 seconds. Press the

key to silence the beeps. Press

to view the trouble con-

dition. The Trouble ( ) indicator will flash. Use the

keys to view troubles.

Alarm Memory

When an alarm occurs, the Alarm Memory Message will be displayed. To view which sensor(s) gener-
ated the alarm, press

.

For the system keypad use the

scroll keys to view the sensors in alarm memory.

Press

to exit. To clear the memory, arm and disarm the system.

If an alarm sounded while armed, the system will automatically go to alarm memory when you dis-
arm the system. In this instance, you should approach with caution, as the intruder may still be within
the building/premises.

Door Chime (Entry/Exit Beeps)

To turn the door chime function on or off, press and hold the Chime key for 2 seconds or press

.

Trouble

Condition

Comments

Action

Service Required
(Press [1] for more
information)

Indicates Low Battery, System Trouble, System Tamper or
RF Jam detected.

Call for service

Loss of AC Power

If the building and/or neighbourhood has lost electrical
power, the system will continue to operate on battery for
several hours.

Check AC
connection
Call for service

Telephone Line
Fault

The system has detected that the telephone line is dis-
connected.

Call for service

Failure to
Communicate

The system attempted to communicate with the moni-
toring station, but failed. This may be due to Telephone
Line Fault.

Call for service

Sensor (or Zone)
Fault

The system is experiencing difficulties with one or more
sensors on the system. Press [5] to display zone(s).

Call for service

Sensor (or Zone)
Tamper

The system has detected a tamper condition with one or
more sensors on the system. Press [6] to display zone(s).

Call for service

Sensor (or Zone)
Low Battery

If the system has been equipped with wireless sensors,
one or more has reported a low battery condition. Press [7]
to display the zone(s). Press [7] again to display WLS keys.

Call for service

Loss of Time & Date

If complete power was lost (AC and Battery), the time
and date will need to be re-programmed. Press [*]

Re-program Time &
Date (page 4)

This manual is related to the following products: