Personalisations, Setting the temperature, Set the drying cycle – Indesit IWDE-127-EU User Manual
Page 25: Functions

25
GB
Personalisations
C
Setting the temperature
Turn the TEMPERATURE knob to set the wash temperature (see Programme table).
The temperature can be lowered, or even set to a cold wash ( ).
Set the drying cycle
Turn the DRYING knob to set the desired drying type.
Two options are available:
A - Based on time: From 40 minutes to 180.
B - Based on the damp level of the dry clothes:
Iron
: slightly damp clothes, easy to iron.
Hanger
: dry clothes to put away.
Cupboard
: very dry clothes, recommended for towelling
and bathrobes.
A cooling stage is foreseen at the end of the drying cycle.
If your laundry load to wash and dry is exceptionally in excess of
the maximum load foreseen (see table opposite), perform the
wash cycle, and when the programme is complete, divide up
the garments and put part of them back in the drum. Now
follow the instructions provided for a dry only cycle. Repeat this procedure for the remainder of the load.
Dry only
Turn the PROGRAMME knob to one of the drying settings (7-8) depending on the type of fabric, then select the desired
drying type using the DRYING knob.
Important: - A spin cycle is carried out during the drying if you have set a cotton programme and a level of dryness (Cupbo-
ard
, Hanger
, Iron
).
- For cotton loads of less than 1 Kg, use the drying programme designed for delicate fabrics.
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.
Table of drying times
The data contained in the
table are purely indicative.
Fabric
type
Load type
Max.
load
(kg)
Cup-
board
Hanger
Iron
Cotton,
Linen
Clothing of diffe-
rent sizes
5
180
170
140
Cotton
Terry towels
5
180
170
140
Terital,
Cotton
Sheets, Shirts
3
140
120
100
Acrylics
Pyjamas, socks,
etc.
1
70
65
60
Nylon
Slips, tights, sto-
ckings, etc.
1
70
65
60
Function
Effect
Comments
Enabled with pro-
grammes:
Delay Timer
Delays the start of
the wash by up to 9
hours.
Press the button repeatedly until the LED corresponding to the desired de-
lay is turned on.
The fifth time the button is pressed, the function will be disabled.
N.B.: Once you have pressed the Start/Reset button, the delay can only be
decreased if you wish to modify it.
All
Easy iron
This option redu-
ces the amount of
creasing on fabrics,
making them easier
to iron.
When this function is set, programmes 6 will end with the laundry left to
soak (Anti-crease) and the Rinse cycle phase
LED will flash.
- to conclude the cycle, press the START/RESET button;
- to run the draining cycle alone, set the knob to the relative symbol
and
press the START/RESET button.
If you also want to run the drying cycle, this button is enabled only if com-
bined with level
(Iron).
1, 2, 3, 4, 6, 9, 10,
Rinse cycle.
Extra Rinse
Increases the efficien-
cy of the rinse.
Recommended when the appliance has a full load or with large quantities
of detergent.
1, 2, 3, 4, 5, 6, 9, 10,
12, 13, Rinse cycle.
1200-600
Reduces the spin
speed.
Tutti tranne
6, 7, 8
and drai-
ning.