Indesit UIAA-12.1 - Manual (Page 21)

GB
21
WATER LEVEL
MAX
WA
TER LEVEL MAX
WA
TER LEVEL MAX
Maintenance and care
Switching the appliance off
During cleaning and maintenance it is necessary to disconnect
the appliance from the electricity supply:
1. set the TEMPERATURE CONTROL knob on
2. pull the plug out of the socket
Cleaning the appliance
• The external and internal parts, as well as the rubber seals
may be cleaned using a sponge that has been soaked in
lukewarm water and bicarbonate of soda or neutral soap. Do
not use solvents, abrasive products, bleach or ammonia.
• The removable accessories may be soaked in warm water
and soap or dishwashing liquid. Rinse and dry them
carefully.
• The back of the appliance may collect dust which can be
removed by delicately using the hose of a vacuum cleaner
set on medium power. The appliance must be switched
off and the plug must be pulled out before cleaning the
appliance.
Avoiding mould and unpleasant odours
• The appliance is manufactured with hygienic materials which
are odour free. In order to maintain an odour free refrigerator
and to prevent the formation of stains, food must always be
covered or sealed properly.
• If you want to switch the appliance off for an extended
period of time, clean the inside and leave the doors open.
Defrosting the appliance
! Follow the instructions below.
Do not speed up the defrosting process by using any tools or
electrical devices other than the scraper provided, you may
damage the refrigeration circuit.
. If the frost layer is greater than 5 mm, it is necessary to defrost
manually:
1. After 24 hours set the TEMPERATURE CONTROL knob on
, which will switch the refrigerator off.
2. Wrap frozen foods in newspaper and place them in another
freezer or in a cool place.
3. Leave the door open until the frost has melted completely.
This can be made easier by placing containers with
lukewarm water in the freezer compartment.
4. Certain appliances are fitted with the DRAIN SYSTEM to lead
the water outside: let the water flow into a container (see
diagram).
5. Clean and dry the freezer compartment carefully before
switching the appliance on again.
6. Wait for approximately 2 hours, i.e. until the ideal storage
conditions have been restored, before placing food in the
freezer compartment.
Precautions and tips
! The appliance was designed and manufactured in
compliance with international safety standards. The following
warnings are provided for safety reasons and must be read
carefully.
This appliance complies with the following Community
Directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent
amendments;
-89/336/EEC of 03.05.89 (Electromagnetic Compatibility) and
subsequent amendments;
- 2002/96/CE..
General safety
• The appliance was designed for domestic use inside the
home and is not intended for commercial or industrial use.
• The appliance must be used to store and freeze food
products by adults only and according to the instructions in
this manual.
• The appliance must not be installed outdoors, even in
covered areas. It is extremely dangerous to leave the
appliance exposed to rain and storms.
• Do not touch the appliance with bare feet or with wet or
moist hands and feet.
• Do not touch the internal cooling elements: this could cause
skin abrasions or frost/freezer burns.
• When unplugging the appliance always pull the plug from
the mains socket, do not pull on the cable.
• Before cleaning and maintenance, always switch off the
appliance and disconnect it from the electrical supply. It is
not sufficient to set the temperature adjustment knobs on
(appliance off) to eliminate all electrical contact.
• In the case of a malfunction, under no circumstances should
you attempt to repair the appliance yourself. Repairs carried
out by inexperienced persons may cause injury or further
malfunctioning of the appliance.
• Do not use any sharp or pointed utensils or electrical
equipment - other than the type recommended by the
*
Varies by number and/or position, available only on certain
models.