beautypg.com

Maintenance and care – Indesit TLA1 User Manual

Page 7

background image

GB

7

Maintenance and care

Switching the appliance off

During cleaning and maintenance it is necessary to

disconnect the appliance from the electricity supply:

It is not sufficient to set the temperature adjustment

knobs on 0 (appliance off) to eliminate all electrical

contact.

Cleaning the appliance

• The external and internal parts, as well as the rubber

seals may be cleaned using a sponge that has been

soaked in lukewarm water and bicarbonate of soda or

neutral soap. Do not use solvents, abrasive products,

bleach or ammonia.

• The removable accessories may be soaked in warm

water and soap or dishwashing liquid. Rinse and dry

them carefully.

• The back of the appliance may collect dust which can

be removed by delicately using the hose of a vacuum

cleaner set on medium power. The appliance must be

switched off and the plug must be pulled out before

cleaning the appliance.

Avoiding mould and unpleasant odours

• The appliance is manufactured with hygienic

materials which are odour free. In order to maintain an

odour free refrigerator and to prevent the formation of

stains, food must always be covered or sealed

properly.

• If you want to switch the appliance off for an extended

period of time, clean the inside and leave the door

open.

Defrosting the appliance

! Follow the instructions below.

Do not speed up the defrosting process by using any

devices or tools, you may damage the refrigeration

circuit.

The refrigerator has an

automatic defrosting

function: water is ducted

to the back of the

appliance by a special

discharge outlet (see

diagram) where the heat

produced by the

compressor causes it to

evaporate. It is necessary

to clean the discharge

hole regularly so that the water can flow out easily.

Replacing the light bulb

To replace the light bulb in the refrigerator compartment,

pull out the plug from the electrical socket. Follow the

instructions below.

Access the light bulb by

removing the cover as

indicated in the diagram.

Replace it with a similar

light bulb within the power

range indicated on the

cover (10W ).

This manual is related to the following products: