Indesit IDCA8350 - Manual (Page 10)

10
EN
Options
The options allow for customising the selected programme according to one’s own needs.
Delay timer
The start of some programmes (see Programmes and options) may be delayed up to 9 hours. Press the button repeatedly to enter
the desired delay time. Before setting a delayed start, make sure that the water container is empty and that the filter is clean.
Post Care
When this option is selected, the drum rotates garments at intervals after the COOL TUMBLE cycle has ended, in order to avoid
creases forming on garments if they cannot be immediately removed at the end of the programme.
Pre Care
When this option is selected in addition to the “Delay timer” option, the drum rotates garments at intervals during the delay period to
avoid creases forming.
High Heat
When a drying time is selected, pressing this button sets high heat drying and the indicator light above the button lights up. The
timed programmes are pre-set to low heat.
! Not all options are available on all programmes (see Programmes and options).
Opening the door
If the door is opened (or the START/PAUSE button is pressed) while a programme is running, the dryer stops and the following may
occur:
• The START/PAUSE button flashes orange.
• When a delayed start is running, the delay countdown continues. It is necessary to press the START/PAUSE button to resume the
“Delay timer” programme. One of the “Delay timer” indicator light flashes to signal the delay time entered.
• It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running pha-
se and the START/PAUSE indicator light stops flashing and turns green.
• During the post care phase, the programme ends. Pressing the START/PAUSE button reactivates a new programme from the
beginning.
• By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green. This
procedure can be used to select the COOL TUMBLE programme to cool garments if they are judged to be dry enough.
Press the START/PAUSE button to start the new programme.
Note: If you have a power cut, switch off the power or remove the plug. When power is restored, plug in the machine, press and
hold the ON/OFF button until the dryer reactivates, then press Start/Pause button.