Ultra Start 1172 SERIES - Manual (Page 4)

This feature is to be used if the remote transmitter is lost or is not communicating with
the system. This will disable the optional starter disable if installed. Follow the steps
below to deactivate your system.
ACTIVATING EMERGENCY OVERRIDE MODE
Turn the Ignition Key ON
(Leave in the ON position)
Press and hold the Valet switch for 8 to 15 seconds
(Time depends on "Valet Settings" Program Option)
The horn will honk 5 times as confirmation that the system is
now in Emergency Override Mode.
DEACTIVATING EMERGENCY OVERRIDE MODE
Turn the Ignition Key ON
(Leave in the ON position)
Press and hold the Valet switch for 8 to 15 seconds
(Time depends on "Valet Settings" Program Option)
The horn will honk 2 times as confirmation that the system is
has exited Emergency Override Mode.
ENTERING REMOTE PROGRAM MODE
The system can lean up to 4 different remote’s. Each remote to be used MUST be
programmed together during the same sequence. For security, when a new remote is
programmed all previous remote’s are deleted. Please see remote operation chart for
information on using Second Car / Pad Lock Operations.
HOLD program switch, the HORN will Honk ONCE and the park lights will turn on.
(If the HORN does not Honk repeat step 1)
CONTINUE TO HOLD until HORN Honks 5 times
Press & Release the START button on each of the remote transmitters
to be programmed.
HORN will Honk 1 time to confirm each remote has been
programmed (If the HORN does not Honk press button again)
PROGRAMMING REMOTE’S
Cycle the Ignition Key - ON/OFF ON/OFF ON (Leaving the key ON)
Turn ignition key OFF to exit remote program mode when
all required remote’s have been programmed.
1 Honk confirms program mode entered followed by 5 Honks confirming
transmitter program mode
1 -
2 -
3 -
4 -
5 -
6 -
PAGE 4
1172 SERIES
OWNER'S MANUAL
SERVICE/ VALET MODE
PAGE 5
1172 SERIES
OWNER'S MANUAL
REMOTE PROGRAMMING