ASKO WL6511 - Manual (Page 26)

25
Customer Care Center
1-800-898-1879
www.askousa.com
Installation instructions
Read these instructions carefully and
completely before you install the machine.
The installation should be carried out by a
qualified person who is familiar with all local
codes and ordinances for electrical and
plumbing connections.
Cosmetic damage must be reported to your
dealer within five days from the date of
purchase. After unpacking the washer,
thoroughly check the unit for cosmetic
damage.
Removing shipping bolts
1. Before operating the washer, remove the
shipping bolts(4ea) along with the rubber.
• If the bolts are not removed, it may cause
heavy vibration, noise and malfunction.
2. Unscrew the 4 bolts with the wrench
supplied. Keep the 4 bolts and wrench for
future use.
• Whenever the appliance is transported,
the transit bolts must be reused.
3. Close holes with supplied cap holders.
Location of your washer
• Check location where the washer will be
installed. Make sure you have everything
necessary for correct installation.
• Do not place or store your washer below 0C
(32F) to avoid any damage from freezing.
• Do not place or store laundry products on
top of washer at any times.
• Install the washer on the horizontal solid
floor. If the washer is installed on an
unsuitable floor, it could make considerable
noise, vibrate severely and cause a
malfunction. If the washer is not level, adjust
the leveling legs up or down to make the
unit level.
• Ventilation openings must not be obstructed
by carpeting when the washer is installed on
a carpeted floor.
• Leave some space. There should be at
least 1/2" clearance on all sides of the unit.
Laundry
Tub
Washer
approx.
2cm
Drain Hose