AEG L 71670 FL - Manual (Page 29)

Problem Possible cause Possible solution
The appliance fills
with water and
drain immediately. The end of the drain
hose is too low. Make sure that the drain hose is
in the correct position.
The washing re-
sults are not satis-
factory. The detergent you used
was not sufficient or cor-
rect. Increase the detergent quantity
or use a different one.
You did not remove the
stubborn stains before
you wash the laundry. Use special products to remove
the stubborn stains.
Incorrect temperature
was set. Make sure that you set the cor-
rect temperature.
Too much laundry load. Decrease the laundry load.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre. If the display shows other alarm codes,
contact the service centre.
ENGLISH
29