Technical specifi cations – Arcam surround sound receiver AVR100 User Manual
Page 16
AVR100
16
AMPLIFIER SPECIFICATION
Output power (20Hz–20kHz at 0.5%THD)
8
Ω, fi ve channels
70W
8
Ω, two channels
90W
8
Ω, single channel
100W
Harmonic distortion, 1W, 8
Ω at 1kHz 0.02% typical
Left/right crosstalk
> 60dB at 1kHz
Frequency response ±1.0dB
20Hz to 20kHz
Inputs
Line inputs:
sensitivity
200mV
input impedance
> 10k
Ω
overload margin
> 20dB
Power amplifi er input sensitivity
740mV (normal gain)
Outputs
Preamplifi er
nominal output level
200mV
maximum output level
3V
Headphones
output
impedance
390
Ω
Physical
Dimensions W x D x H
430 x 425 x 150mm
Weight net
11.9kg
Weight packed
14.1kg
Mains voltage
230V ±12%
120V
±12%
Power consumption (maximum)
500VA
Accessories supplied
Mains lead
CR-340 remote control
2 x AAA batteries
AM loop aerial
FM ribbon aerial
Technical specifi cations
RADIO SPECIFICATION
FM section
30 preset stations available
RDS Station Identifi cation, Radio Data Display
FM tuning range
87.5 to 108MHz
FM sensitivity
< 6µV
THD: mono
<
0.25%
stereo
<
0.35%
Signal/noise ratio:
mono
>
72dB
stereo
>
66dB
Pilot tone suppression
> 60dB
Alternate channel selectivity IHF
> 60dB
Capture ratio
< 3dB
AM section
10 preset stations available
AM tuning range
10kHz step
530 to 1710kHz
9kHz step
531 to 1602kHz
Usable sensitivity
< 30µV
IF rejection
> 36dB
Signal/noise ratio, 5mV input
> 38dB
THD, 5mV input
< 3%
E&OE
Continual improvement policy
Arcam has a policy of continual improvement for its products.
This means that designs and specifi cations are subject to
change without notice.
NOTE: All specifi cation values are typical unless otherwise
stated.