Measurements, Normal measurement – A&D UA-767 User Manual

Page 9

English 8

Measurements

Model UA-767

is designed to detect the pulse and to inflate the cuff

to a systolic pressure level automatically.

If your systolic pressure is expected to exceed 230 mmHg or you use the
optional small cuff, read "Measurement with the desired systolic
pressure" on next page.

Normal Measurement

Place the cuff on the arm (preferably the left arm).

Sit quietly during measurement.

Press the

START

button.

The last data of systolic and diastolic
pressure and pulse rate are displayed
briefly. Then the display changes, as
indicated in the figure at the right, as the
measurement begins. The cuff starts to
inflate. It is normal for the cuff to feel very
tight. A pressure bar indicator is displayed,
as in the figure at the right, during inflation.

Note: If you wish to stop inflation at any time,

press the

START

button again.

When inflation is complete, deflation starts
automatically and the

(heart mark)

blinks, indicating that the measurement is
in progress. Once the pulse is detected,
the mark flashes with each pulse beat.

Note: If an appropriate pressure is not

obtained, the device starts to inflate
again automatically.

When the measurement is complete, the
systolic and diastolic pressure readings and
pulse rate are displayed. The cuff exhausts
the remaining air and deflates completely.

Press the

START

button again to turn

off the power.

Note: Model UA-767

is provided with an automatic power shut-off

function. Allow at least ten minutes between measurements on
the same person.

At heart level

The last data

at initial display

Starts inflation

Pressurizing

Measurement

in progress

Systolic pressure

Diastolic pressure

WHO classification

Pulse rate

Exhausts remaining

air automatically

START

button