Aiwa CSD-TD20 - Manual (Page 8)

ENGLISH
7
SETTING THE SLEEP TIMER
The unit can be turned off automatically at a specified time.
1
Keep SLEEP pressed until “10” flashes in the
display.
2
Within 4 seconds, press r or t to specify
the time until the power is turned off.
Each time it is pressed, the time changes between 10
and 90 minutes in 10-minute steps.
To check the time remaining until the power is turned off
Repeat step 1 shown above. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Display the remaining time and press r or t
repeatedly until OFF is displayed.
NOTE
If the unit is turned off during tape playback, x on the deck
will not be released. Press Z to release x .
GENERAL
SOUND ADJUSTMENT
VOL (volume)
Press VOL i or k . The volume level is displayed as a
number from 0 to MAX (25).
• The volume level is automatically set to 14 if the power
is turned off when the volume level is set to 15 or more.
(except when turning the power back on within 4
seconds)
To display the volume level when a function other than
TAPE function is selected
Press VOL i or k . The volume level is displayed for 4
seconds.
3-MODE EQUALIZER
Press 3-MODE EQUALIZER until one of the indicators
lights up.
The equalizer mode changes to ROCK, POP, JAZZ or no
equalization, cyclically.
ROCK - Emphasizes the high and low range of music.
POP - Emphasizes voice and midrange of music.
JAZZ - Emphasizes the low range of music.
T-BASS system
The T-BASS system enhances the realism of low-
frequency sound.
Press T-BASS and the T-BASS indicator lights up.
QSOUND system (CSD-TD21 only)
This system provides a rich, three dimensional sound area
for stereo sources.
You can enjoy more enhanced sound.
Press QSOUND and the QSOUND indicator lights up.
• At higher volumes, turning QSOUND on may cause
sound distortion. In this case, make the volume down.
Specified time While the sleep timer works,
the dot keeps flashing.