APW Wyott M2000 - Manual (Page 7)

7
ONE-TIME BOIL OUT OF CONVEYOR
NOTE: This is for experienced operators only, and in stores that approve this
operation.
1. Turn off power and drain the oil from one of the Fryers, and allow it to cool.
2. Turn Toaster main power switch off. Remove power supply plug from the wall
outlet.
3. Some surfaces will remain hot after toaster is turned off. Allow time for toaster to
cool. (15-30 minutes) Use caution during disassembly and cleaning.
4. Grasp the left side of the Butter Roller shaft. Lift it up and to the left to remove
from drive assembly.
5. Remove the Butter Pan.
6. Remove the Top and Bottom Front Panels.
7. When the fryer has cooled and has drained, close the drain valve.
8. Remove the Conveyor assembly by grasping the two handles at the top, and
lifting forward until it clears the gears.
9. Gently place the Conveyor Assembly into the Fryer.
10. Add water to the cooled Fryer leaving enough room to add two (2) gallons of
“INSIDE OUT” 3 IN 1 HEAVY DUTY CLEANER and the Conveyor Assembly.
11. Add additional water to the Fryer, if necessary, to completely cover the Conveyor
Assembly.
12. Set the temperature of the Fryer to 200ºF, and allow the conveyor to soak in the
solution for 60 minutes.
13. Shut off the Fryer and allow the conveyor to cool.
14. NOTE: Drain the solution prior to removing the Conveyor Assembly. After
the conveyor has cooled, remove the conveyor from the Fryer. If there are areas
with bun oil, use a stiff non-metal brush or plastic pad to remove. Insure the
chains are clean and free from impediment. Use a brush to remove any soil or
impediment remaining on the chain.
15. Rinse conveyor with hot water and allow to drain. Lubricate both chains
thoroughly with vegetable oil. Bun oil may be used if it contains no animal fats,
salts or dairy products. Note: Chain Lubrication is critical to chain life. Oil
chain daily.
16. Before assembly of the conveyor check the Following: Conveyor Assembly
hardware to insure fasteners are tight and there are no signs of wear, Gears are
tight on the Conveyor shaft and the Motor Shaft and the Hanger Bracket screws
are tight and the brackets have not shifted during use.
17. Gently replace conveyor into toaster. Replace all removed parts. Plug power
supply cord into wall. Turn main power switch on. Turn conveyor switch on.
LAST IMPORTANT NOTE: Daily-cleaning instructions of conveyor should be
followed after this boil out. The conveyor must stay clean to optimize speed and bun
temperature. KEEP CONVEYOR LOOKING NEW.