Aruba Spa Hot Tub Models 2003 User Manual

Page 15

Pump button

Press Pump key to turn pump on(low speed). Press a second

time to change the pump to high speed. A third time turns

the pump off. A built-in timer automatically turns pump off

after 20 minutes, unless it has been manually deactivated.

The “Pump” indicator lights up when the pump is on.

Light or LED

The control panel button designated “LIGHT” activates the

spa light when pressed. The light turns off after a two-hour

default.

The LED light (available on the Deluxe and Executive Aruba

models) is activated by the light button. Pressing the light

button once turns on the multi colour display. Pressing the

light button off and then on will scroll through the colour

display. Pressing the light button once again, off and on, will

hold at a desired colour.

Filter Cycle Pr

ogramming

Proper filtration is an important key to maintaining the clar-

ity of your spa’s water. The filter system is designed for

unsurpassed effectiveness at removing debris and suspend-

ed particles from the water while the water is circulating.

The system automatically performs two filter cycles per day,

at 12-hour intervals. During a filter cycle, the pump is acti-

vated for a programmed number of hours.

Press and hold Light key for 5 seconds. The display will

show a value that represents the filter cycle duration in

hours.

Use Up or Down arrow key to change setting.

0 = no filtration

12 = continuous filtration

When the desired setting is displayed, press the Light key

again. The filter cycle will start.

Note: after a power failure, the filter cycle duration will return to
its default value (6 hours). In this case the first filter cycle will start
12 hours after power has been restored.

Note: also that to prevent excessive water temperature caused by too
long filter cycles, the system will cancel a filter cycle after 3 hours if
water temperature raises more than 2 °F (1°C ) above set point. In
this case, the “filter” indicator will flash.