Nilfisk-ALTO DJM-3 - Manual (Page 11)

10
3.3.1 AC Inlet and Fuse Holder 27
3.3.2 POWER Switch
This switch turns the Mixer ON and OFF.
28
3.3.3 MAIN OUT
Both MAIN output and TAPE output are RCA types connectors. Yes the same largely used in hi-fi and are low
impedance. Through the MAIN output you can connect your DJM 3 to an amplifier. Through the TAPE output
you can connect your DJM 3 to a tape recorder.
29
3.3.4 EFFECTS send and return
You can send the PFL (pre fader level) signal through the SEND sockets to a signal processor such as reverb,
equaliser, etc. Then from the same effect unit you bring the signal back into the DJM 3 via the RETURN
sockets and the audio signal is routed into the MAIN output.
30
3.3.5 INPUT
- PHONO input: Both Channels feature PHONO inputs including RIIA preamplifier for turntable. PIN (RCA) jacks
shall be used to connect the turntable.
- LINE input: Through these RCA type sockets you can connect a CD player, an MD player or any other high level
device such as Tape Recorder, DAT, etc,
Important Notice: If you wish to connect LINE level devices into the LINE/PHONO input, make sure that the LINE/
PHONO switch is on LINE position otherwise the sensitive RIAA preamplifier built-in in the Phono input will be
overloaded and will produce distortion.
31
3.3.6 GND screw
This grounding connection is provided for your turntables.
32
3.3.The Rear Panel
PHONO LINE LINE
RETURN
TO MAIN
SEND
FROM PFL TAPE MAIN
L
R
POWER
PHONO
LINE
PHONO
LINE
GND GND
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: SHOCK HAZARD
AVIS: RISQUE DE CHOC ELECTRIQUE - DO NOT OPEN
- NE PAS OUVRIR
MAIN OUT INPUT 2 INPUT 1 EFFECTS
PHONO
ON
OFF
AC INPUT
EUROPE
210-240V
50Hz
RATED POWER CONSUMPTION: 12W
Fuse:T200mAL
MODEL SERIAL
Apparaten skall anslutas till
Jordat uttag nar den ansluts
Till ett natverk
Useonly with a250V fuse Useonly with a250V fuse Useonly with a250V fuse
27 28 29 30 31 32
UK/AUST
210-240V 50Hz
Fuse:T200mAL
USA / Canada
100-120V 60Hz
Fuse:T400mAL
The fuse holder position (please follow the triangle that indicated the voltage accepted by the unit) can be changed
only by a qualified Engineer. Please check the Voltage accepted by the unit and the Voltage available from your
AC sockets before connecting the unit to the Mains.