Technical characteristics, Using the drilling template, Mounding the parts onto the wooden panel (door) – Ariston CD12TUK User Manual

Page 14: Mounting the panel into the machine, Inserting the machine into the cabinet

m odel CD 12 T

dim ensions w idth cm 59,8

height cm 82

depth cm 53,7

capacity 1 - 5 Kg

electrical

connections

voltage 240 Volt 50 Hz

m axim um absorbed pow er 2300 W

w ater

connections

m axim um pressure 1 M Pa (10 bar)

m inim um pressure 0,05 M Pa (0,5 bar)

drum capacity 42 litres

spinning speed up to 1200 rpm

This appliance conform s w ith the follow ing E.E.C.

directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and

subsequent m odifications

- 89/336/EEC of 03/05/89 (Electrom agnetic

Com patibility) and subsequent m odifications

Using the Drilling Template

Place the top edge of the drilling template so that it is flush

with the top edge of the panel, making sure that it is positioned
correctly and centered in the horizontal direction (use the dotted
lines on the edges to line the template up). Mark the points on
the panel for the four holes.

Use an appropriately sized router to mill the holes for the

two hinges, the rubber plug and the magnet.

Mounding the Parts onto the Wooden Panel
(Door)

Insert the hinges into the holes (the movable part of the

hinge must be positioned facing away from the panel) and
fasten them with the 4 type A screws.

Insert the magnet into the top hole on the opposite side

of the hinges and fasten it with the two type B screws.

Insert the rubber plug into the bottom hole.

The panel is now ready to be mounted onto the machine.

Mounting the Panel into the machine

Insert the nib of the hinge (indicated by the arrow in fig. 10)
into the hole for the hinge and push the panel towards the
front of the machine. Fasten the two hinges with the type
D screws.

Inserting the machine into the Cabinet

Push the machine into the opening, aligning it with the

cabinets (fig. 15).

Regulate the adjustable feet to raise the machine to the

appropriate height.

To adjust the position of the wooden panel in both the

vertical and horizontal directions, use the C and D screws,
as shown in fig. 16.

If the machine is installed at the end of a set of modular

cabinets, mount either one or both of the guides for the
base molding (as shown in fig. 17) with the type F screws.
Adjust them for depth based on the position of the base
molding, and, if necessary, fasten the base to the guides.

Technical characteristics

90 mm

570

min

820

537

598

820

870

600 min

Fig. 17

Fig. 15

Fig. 16

Control programs in compliance with IEC regulation 456:

Cotton program:
Turn knob A to the "program 2"setting;
Turn knob B to the "60°C" setting;
Press Extra economy button.