Avanti WD361 - Manual (Page 8)

8
Important Safety Instructions
?
WARNING
?
To reduce the risk of burns, fire, electrical
shock, or injury when using your appliance,
follow these basic precautions:
?
Read all instructions before using the water dispenser.
?
Never clean parts with flammable fluids. The fumes can create a fire hazard or
explosion.
?
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other water dispenser. The fumes can create a fire hazard or explosion
?
Do not plug unit into receptacle until you ensure the water tank switches are off.
-Save these instructions-
INSTALLATION GUIDELINES:
?
Remove the exterior and interior packing.
?
Place your appliance on a floor that is strong enough to support the dispenser when it is fully
loaded. If it does not sit level on the floor, adjust the front right foot to level the unit well to the
floor. Note: Only the front right foot is adjustable.
?
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the appliance not to perform
properly.
?
Allow 2 inches of space between the water dispenser and the wall, which allows for proper air
circulation to cool the compressor.
?
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not cut or
remove the third (ground) prong from the power cord under any circumstances. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
?
This water dispenser is not recommended for outdoor use.
?
Do not locate the dispenser in area where the temperature may fall below freezing (32 º F).
?
Keep area around dispenser free of dust and dirt.
?
Keep the reserve supply of water bottles away from excessive heat and light.
?
Never unplug the water cooler, except for maintenance.
Height Adjustment
? Unit is provided with four feet extensions, if you wish to make the unit taller, just attach all four
parts to the bottom feet by placing them on existing feet and pushing firmly to ensure a tight fit.
Unit will be slightly taller. The adjustable foot can still be used for leveling after the extension
part is inserted.