Air-O-Swiss AOS 2055D User Manual
Page 8
8
en
How it works
Your appliance
• washes and humidifies the air without using filter mats
• works quietly in two operation modes
• is manufactured from highquality, longlife
components.
• has a large cleansing capacity through preionization.
The individual dust particles are ionized (charged) and
stick to the humidifier discs.
Special humidifying discs rotate in a water bath inside the
unit; this cleanses the air passing over them of impurities
in a natural way – in the same way that air is washed by
the rain in nature.
The air humidification takes place according to the self
regulating principle of cold evaporation. The appliance
therefore generates ideal air humidity, without the need for
additional control units.
A specially tuned antibacterial protection system (Ionic Sil
ver Stick
®
) prevents the formation of germs in the water of
the base unit. No chemical additives are therefore required
to keep the water clean.
Unpacking
• Remove the appliance carefully from the packaging
(10 – 12). The top section is only placed on the base; it
is NOT attached.
• Remove the plastic bag from the unit (13).
• Check the details of the electrical supply on the rating
plate (14).
• Use the original packaging to store the appliance if you
do not use it throughout the year.
10
14
11
12
1
Adjusting the cable length
The overall length of the cable is approx. 6,5 ft / 2 m, but
this can be adjusted as required.
• Switch the appliance off and remove the power plug
from the electrical supply. Do not pull on the cable (15).
• Open the cover (16 and 17)
1. Insert the screwdriver (into the whole provided)
2. Press outwards
3. Push upwards
• Pull the cable from the cable compartment (18)
• Adjust the cable length by pulling/pushing
• Store the remaining cable in the cable compartment
• Close the cover (19)