Battery installation and charging – AT&T CL81301 User Manual
Page 4

3
Battery installation and charging
Once you have installed the battery, the screen indicates the battery status. For
best performance, keep the handset in the telephone base or charger when not
in use. The battery is fully charged after 0 hours of continuous charging.
BY
1021
BT183342/BT283342
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment, matching
the color-coded label.
Insert the supplied
battery with the label
THIS SIDE UP facing up
as indicated.
Step 2
Align the cover flat
against the battery
compartment, then
slide it upwards until it
clicks into place.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute.
Step 3
Charge the handset by placing it face forward in the
telephone base or charger. The
CHARGE light on the
top of the handset is on during charging.
IMPORTANT INFORMATION
. Use only the supplied rechargeable battery or replacement battery (model BT6634).
To order, visit our website at
www.telephones.att.com
or call
1 (800) 222-3111
. In Canada, dial
1 (866) 288-4268
.
. If you do not use the handset for a long time, disconnect and remove the battery to
prevent possible leakage.
After you install your telephone or power returns following a power outage, the
handset will prompt you to set the date and time. To skip setting the date and
time, press
OFF
/CANCEL.
CHARGE light