Agri-Fab 45-03085 - Manual (Page 4)

4
TO REMOVE UNIT FROM CARTON
Cut from top to bottom all four corners of the carton •
and lay panels flat. See figure 1.
Remove the lag screw that holds the floating hitch to
•
the packing skid.
Disassemble and discard carton's wood top and side
•
supports.
Remove four hex bolt, hex nuts and flat washer from
•
the hold down brackets at the rear of the carton.
Remove and save the two Flat Washers and Cotter Pins
•
from rear axle. Reuse when attaching gauge wheels.
Discard all other packing hardware and hold down
•
brackets.
ASSEMBLY
TO iNSTALL ThE TiLLER GAUGE WhEELS
Assemble Gauge Wheels onto the Rear Axle with •
the extended end of Hub facing inward. Secure with
the Flat Washers and Cotter Pins which you removed
from the axle during unpacking. See figure 2.
3/8" NYLOCK
NUT
TO iNSTALL ThE TiLLER TiNE ASSEMBLiES
Attach the floating hitch to the tractor's draw bar. •
Refer to OPERATING INSTRUCTIONS on page 6.
Remove the preassembled 3/8" x 2" hex bolt and 3/8" •
nylock nut from the L.H. Tine Assembly. Slide the tine
assembly onto the Transmission Axle on the left side
of the tiller and secure with the hex bolt and nylock
nut. See figure 3. Repeat for the R.H. side.
TO INSTALL (WHEEL) WEIGHTS TO TILLER
NOTE: Weights are not furnished with Tiller. 30 lb. tractor
wheel weights may be purchased to mount to Tiller if
extra weight is required. (Refer to
OPERATION section.)
Remove two Hex Bolts and Nuts from each Tine •
Shield, located approximately 3-1/2" from front edge.
See figure 4.
Place (Wheel) Weights on Tine Shield and secure
•
with long Bolts and Nuts furnished with Weights. See
figure 4.
FiGURE 1
FiGURE 2
FiGURE 3
FiGURE 4