Actron OBD II POCKETSCAN CP9125 - Manual (Page 10)

Erasing Diagnostic Trouble Codes and Data
Erasing allows the PocketScan TM Code Reader to delete the codes
and I/M Monitor status from the vehicle’s computer modules.
Only Erase Diagnostic Data after checking
system completely and writing down results.
Avoid Cooling Fan! Fan may turn on
during test.
1.Turn Ignition Key to the Off Position.
2. Locate and Plug in Data Link
Connector (DLC.)
NOTE: The data link connector
should be located under
the dashboard on the
driverside of the vehicle.
If the data link connector is not located under the
dashboard as stated, a label describing the location of
the data link connector should be there.
3. Observe Display toggles between
“Pocket” and “Scan”.
4.Turn Ignition Key to the ON Position
leaving Engine Off.
NOTE: Make sure that the Ignition Key is
ON and NOT in the Accessory
Position.
IMPORTANT
! WARNING
OF
F
ON
OF
F
ON
Scan
10