Audiovox DV 7300 - Manual (Page 23)

- 22 -
SYMPTOM CAUSE (AND REMEDY)
TROUBLE SHOOTING GUIDE
• The region number of the disc doesn't match the region number of this unit. No picture
No sound or only a
very low-level
sound is heard.
No power. • Ensure the AC power cord is connected.
The picture is not
clear.
• The TV is not set to receive DVD signal output.
• The video cable is not connected.
• The TV is not turned on.
• Clean the disc.
• If video from your system has to go through your VCR to get to your TV, the copy-
protection applied to some DVD programs could affect picture quality.
• The disc is scratched.
• The DVD unit may be set to progressive scan; moreover, TV does not support
progressive scan component video signal. Set the Video Out to “CVBS" mode.
• The location and orientation of the antenna are incorrect. If you use an indoor
antenna, change to an outdoor antenna.
• The TV antenna wire is too close to the unit. Separate the TV antenna wire from
the unit.
Severe hum or noise
is heard.
The remote does
not function.
• Ensure the speakers and equipment are connected securely.
• The system is in Pause mode or in Slow-motion Play mode. Press the PLAY
button to return to normal play mode.
• Fast forward or fast reverse is performed. Press the PLAY button to return to
normal play mode.
• Make sure the AUDIO output and AV IN input connections are correct.
• Adjust the speaker volume.
• Ensure the speakers and equipment are connected securely.
• Ensure the connecting cords are away from a transformer or motor, and at least
10 feet (3 meters) away from a TV set or fluorescent light.
• Move your TV away from the audio equipment.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with
alcohol.
• Clean the disc.
• Vibrations from the speakers are affecting the unit.
• Remove any obstacles between the remote and the unit.
• Use the remote near the unit.
• Point the remote at the remote sensor on the unit.
• Replace the batteries in the remote.
• There is no disc inside ("No Disc" appears on the TV screen).
• Insert the disc correctly with the playback side facing down on the disc tray.
• Clean the disc.
• A non-VALID disc has been inserted. The unit and disc region number are incom-
patible.
• Condensation may have formed inside the unit due to a sudden change in
temperature. Wait approximately an hour for it to clear and try again.
The disc does not
play.
The DVD door
cannot open.