Campbell Scientific RavenXTG Sierra Wireless Cellular Modem - Manual (Page 9)

RavenXTG GPRS/EDGE Sierra Wireless Cellular Modem
Typical Current Drain (at 12 Vdc): 50 mA dormant (idle for 10 to 20 seconds),
120 mA transmit/receive
Input Voltage Range: 6 to 28 Vdc
Operating Temperature Range: –30° to +65°C
Operating Humidity Range: 5% to 95% RH non-condensing
Status LEDs: Power, Network, Signal, Activity
Dimensions
Width: 7.6 cm (3 in)
Depth: 2.5 cm (1 in)
Length: 10 cm (4 in)
Weight: <0.5 kg (<1 lb)
4. Configuration
4.1 Base Station Requirements for RavenXTG
PC running Campbell Scientific’s LoggerNet or PC400 software, with access
to the Internet.
4.2 Datalogger Site Equipment
• RavenXTG modem with power cable (included with modem).
• Datalogger—21X, CR510, CR10(X), CR23X, CR7, CR1000, CR5000,
CR3000, CR800.
• Modem Interface
If connecting to CS I/O port:
SC105 or SC932A Interface—connects the modem to the 21X,
CR510, CR10(X), CR7, or other dataloggers’ CS I/O port.
The SC105 must be configured for use with the modem using the
Device Configuration Utility. Settings should be:
CS I/O Mode: SDC Address 7
RS-232 Mode: Modem
Baud Rate: 115.2K or 9600 baud depending on datalogger model
8 data bits, 1 stop bit, no parity
If connecting to RS-232 port:
PN 18663 Null Modem Cable—connects the modem to the
CR23X, CR3000, CR800, CR2XX, CR1000, or CR5000 RS-232
port.
3