iPazzPort KP-810-16BAR - Manual (Page 14)

Manual Tuning :
When the cursor appears an adnormal shifting or shaking .
Please do the following steps :
1. Please place the devise flat on the table until the cursor stabilized .
2. Initialization- press and hold ESC + G keys for around 3 seconds
until the LED- flashing lite off .
Auto- Tuning
A. The Cursor may be drifted or shaking due to sudden voltage or
temperature changed. Please run the Auto- tuning. Place the devise
flat on the table around 5 seconds, the cursor should be stay and
recovered from shaking.
B. The Cursor may stop or no response during devise power on.Run the
Auto- tuning. Place the devise flat on the table for around 5 seconds,
the cursor should be re- activated.
C.The Devise is able to operate bidirectional ( horizontal or vertical ) by
press and hold ESC+ FN keys simultaneously for 3- 5 seconds. If the
cursor is not effectively response, please run the auto- tuning . Place
the devise flat on the table for around 3- 5 seconds, the devise should
be auto- adjusted to the commands in selecting of either working
horizontally or vertically.
FQA