Altinex System Analog Interface VA6834FC - Manual (Page 13)

INTERFACES
12
PIN
No. MAC VGA SUN
A1 n/a n/a Red
A2 n/a n/a Green
A3 n/a n/a Blue
1 Red Gnd Red N/C
2 Red Green N/C
3 C.Sync Blue Sense
4 ID Bit 01 ID Bit Sense Rtn
5 Green N/C C. Sync Sens
6 Green Gnd. Red Rtn. N/C
7 ID Bit 02 Green Rtn. N/C
8 N/C Blue Rtn. N/C
9 Blue N/C N/C
10 ID Bit 03 Gnd N/C
11 C/V Gnd. ID Bit
12 V. Sync ID Bit
13 Blue Gnd. H. Sync.
14 H. Gnd V. Sync
15 H. Sync N/C
Table 7. Common Computer Video Cards pin-out.
TROUBLESHOOTING GUIDE 10
1. The power, LED should be ON when the
correct voltage is applied to Interface.
2. The Termination dipswitch should be in the
ON position if no Y cable (breakout) is used
on the input.
3. Make sure that the cables have the correct
pin-outs and the connection and quality of the
cables are good.
4. Make sure that the source and display are
scan-rate compatible. The projector should
support an appropriate signal format (RGsB,
RGBS or RGBHV). Connect the projector
directly to a computer with a shorter cable to
verify the compatibility of the display and the
source.
5. If you are using output RGBS or RGsB then
the HV Output dip-switch is in the OFF
position and the composite sync signal is
taken from the sync connector. If the display
needs an RGBHV signal then the HV Output
dip-switch should be ON if sync and vertical
connectors are used.
6. If the desired output is RGsB then the Sync
on Green dipswitch should be ON.