Matrix Orbital LK162B-7T - Manual (Page 12)

Command Summary 8
4 Hardware
4.1 Standard Model
Communication/Power Header
Figure 7: Communication/Power Header
Table 4: Communication/Power Pinout
Pin Function
1 Vcc
2 Rx (SCL)
3 Tx (SDA)
4 Gnd
The Communication/Power Header provides a standard connector for interfacing to the LK162B-7T.
Voltage is applied through pins one and four of the four pin Communication/Power Header. Please
ensure the correct voltage input for your display by referencing Voltage Specifications before connecting
power. Pins two and three are reserved for serial transmission, using either the RS-232/TTL or clocking
data through the I²C protocol, depending on what has been selected by the Protocol Select Jumpers.
The versatile Tyco 640456-4-LF style header used can be mated to a number of connectors, the Molex
22-01-3047 for example.
Serial DB9 Connector
Figure 8: Serial DB9 Connector
Table 5: Serial DB9 Pinout
Pin Function
2 Tx
3 Rx
5 Gnd
9 NC/Vcc*
The LK162B-7T provides a DB-9 Connector to readily interface with serial devices using EIA232 standard
signal levels. It is also possible to communicate at TTL levels of 0 to +5V by setting the Protocol Select
Jumpers to TTL. As an added feature it is also possible to apply power through pin 9 of the DB-9
Connector in order to reduce cable clutter. A standard male DB9 header will provide the perfect mate
for this connector.
*Note: Do not apply voltage through pin 9 of the DB-9 Connector AND through the Communication/Power Header
at the same time.