AEG OKO-LAVAMAT 82730 - Manual (Page 35)

Instructions for use
35
Washing not well spun.
Residual water still vis-
ible in the drum.
Fault code
(2
ap-
pears.
Drainage hose bent. Remove the bend.
Maximum pump head (outlet
head 1m from unit's floor
surface) exceeded.
Consult Customer Service.
They can supply a retrofit kit
as a special accessory for de-
livery heads of more than
1m.
Solution pump blocked.
Switch off the unit and pull
out the mains plug. Clean
the solution pump.
If a siphon is connected: Si-
phon blocked.
Clean the siphon.
The filling door cannot
be opened with the
unit switched on.
Door locked for safety rea-
sons (display DOOR/LIGHT,
DEUR/LICHT, PORTE/ ECLAIR.
is off).
Wait until the display DOOR/
LIGHT (DEUR/LICHT, PORTE/
ECLAIR.) lights up green.
The program saving function
is set.
Cancel the program saving
function (see section ”Pro-
gram saving”).
Washing detergent res-
idues form in the
washing detergent
drawer.
Water valve not fully opened. Open the water valve fully.
Filter in the screw connec-
tion of the intake hose on
the water valve or on the
unit is blocked. Close the water valve. Un-
screw the intake hose from
the water valve and from the
unit and clean the filter.
The rinsing water is
murky.
The cause is probably a de-
tergent with a high silicate
content. No negative influence on the
rinsing result, possibly use
liquid detergent if necessary.
The corresponding dis-
play does not light up
when one of the addi-
tional program but-
tons is pressed.
The selected additional pro-
gram cannot be combined
with the set program.
Make another selection.
The program sequence
indicator flashes con-
stantly.
Program saving function
switched on; The program
selector was accidentally re-
adjusted during the washing
cycle.
Turn the program selector
back to its original position
(see ”Program saving”).
Problem Possible Cause Remedy