beautypg.com

Vi operation and maintenance – AMICA IH 17200 E DE User Manual

Page 33

background image

33

1. Operational safety.
All safety instructions included in chapter IV must be observed. Textile grease filters and carbon filters

should be replaced and aluminium filter should be cleaned according to manufacturer’s instructions, or

more frequently in periods of intensive use (more than 4 hours a day). If a gas cooker is used it is for­

bidden to leave uncovered flame. When removing pots from gas burners set the flame to its minimum

level. Always make sure that flame does not extend outside the pot. Such a situation causes undesired

energy losses and dangerous heat build­ups. The hood should not be used for other purposes than

those for which it was designed.

VI OPERATION AND mAINTENANCE

EN

2. Operation:
2.1 Control panel
The cook hood fan can operate at 5 speeds. Select the fan speed appropriate for cooking intensity. To

run the fan press the „ ” button on the control panel (Figure 1, item 3). Touch the „

>

”. sensor each

time you want to increase the fan speed or touch the ” ” sensor to reduce the fan speed. When

you turn on the cooker hood the fan always runs at speed 2. Touch the ” ”, sensor to activate the

countdown timer. Touch the „ „ sensor to activate the timer. The appliance will turn off after 15 minutes.

When the timer is counting down the digit will blink on the display and the appliance will turn off after

15 minutes.

To remove any residual odours and vapour from the kitchen it is recommended to use the hood for

several minutes after cooking.

Lighting
Your cooker hood features LED lighting. Touching the ” ” sensor on the control panel (Figure 1,

item 3) to turn on or off the lighting.

Remote control (Fig. 19)

Your cooker hood can be controlled by a remote control.

Remote control functions are described below:
A. Turn the fan on/off

B. Increase the fan speed

C. Reduce the fan speed

D. Turn the lights on/off

Touch the POWER sensor to turn on the appliance. The fan will run at speed 2.

Hood lighting can be switched on independently of the „POWER” sensor.

To use the remote control:

­ Gently bend the tab and pull out the battery compartment cover.

­ Place the new batteries in the remote control according to the markings inside battery compartment.

­ Close the battery cover.

­ Point the remote control toward the front of the cooker hood.

Ensure there are no obstacle between the remote control transmitter and the sensor on

the cooker hood.

Fluorescent light can interfere with the remote control operation.