Burr King M40 CombiPak - Manual (Page 13)

See our catalog at www.burrking.com Contact us at [email protected] 7
The media discharge chute is located on the lower portion of the machine right side. The chute plug may
be removed by pulling it free of the tub after loosening the retaining clamp. With the machine operating,
the media and parts (if smaller than the tube diameter) will cascade from the tube to a container of your
choice.
Maintenance of your Burr King Model 40 vibratory chamber
Warning: NEVER open the machine service access panels without first removing electrical power.
We recommend that your main electrical service to the unit be equipped with an OSHA approved
lockout-tagout switch.
Maintenance includes:
a. Cleaning the unit, and assuring mechanical fasteners are secure.
b. Applying grease to the main shaft bearings. 1 oz of grease should be applied to each
main shaft bearing every 200 hours of operation. Use a lithium soap (NLGI-2) base,
extreme pressure rated grease. Failure to use the prescribed grease will result in
premature bearing failure.
A tube of the recommended grease is included with each machine. Do not mix grease
types and manufacturers. Burr King recommends Sta-Lube P/N SL3160.
c. If drive belt adjustment or replacement is necessary. Do not over tighten the drive belt.
Proper operation of the M40 demands that the drive belt be operated much more
loosely than ordinary motor belt drive systems. A properly installed v-belt can be easily
compressed side to side with light pressure. Numerically, a properly set belt will require
about 5 pounds compression to squeeze the belt sides to within 3.5 inches of each other.
d. If the motor is equipped with a zerk fitting, grease on the same schedule as the main bearings.
Warranty service and replacement parts
Should you require warranty service, or replacement parts, please contact your Burr King distributor. The
Burr King factory may be reached at 1-800-621-2748. The motor manufacturer warrants the main drive
electric motor; to obtain motor warranty service contact the motor manufacturer’s service center in your
area. NOTICE: when inquiring about warranty service or replacement parts please be prepared to
provide the actual machine part number, and its serial number.
Modifications to your vibratory chamber
Modification of the machine from its as shipped condition from the factory may create a safety
hazard, and may void the factory warranty. If you have any questions in this regard please consult
the factory before making any modifications.
Thank you for purchasing your VibraKING 40 chamber. We are confident that it will serve you
well for years.
Burr King Manufacturing