Burr King Model 562 User Manual
Page 9
See our catalog at
www.burrking.com
Contact us at
DOC 560OP-99 REV 06/99
3
Maintenance for the model 562
FIRST DISCONNECT THE MACHINE FROM ITS AC POWER SOURCE.
* Every thirty days apply light machine oil to the rear wheel support (P/N 435) to rear wheel
handle (P/N 537G) interface. Two drops of oil is sufficient.
* Every thirty days check the v-belt (P/N 429) tension. If you can hear the belt “slap” the v-
belt guard (P/N 428) when the drive motor starts, the v-belt may require re-tensioning. Do
this by loosening the four bolts (P/N 2) that secure the motor to the base (P/N 731) and slide
the motor to the rear. Tighten the four bolts (P/N 2).
* Daily vacuum or otherwise remove dust and debris build-up from the machine and the
machine belt track.
There are no other maintenance actions required. All bearings are sealed for life and require
no additional lubrication.
------------------------------------------------------------------------------------------------------------
Remember for operator safety and the continued effectiveness of your model 562:
Do not defeat the safety guards and other safety provisions of the model 562.
Do not operate the model 562 with the safety guard open or the contact wheel
guard/platen assembly (or internal grinding attachment) removed.
Do not reach inside the safety guards while the machine is running. To do so is
hazardous.
Do not use fluids in your grinding process unless your model 562 is designed for liquid
operation (NEMA 4, 4X). To do so may create an electrical safety hazard.
Do not use your model 562 to grind/polish explosive materials such unless it is equipped
with explosion proof electrical devices and motor.
Do not mix alloys in your grinding. To do so may create an explosion hazard.
Do not use stone or vitreous wheels on the model 562. To do so will create an operator
safety hazard.
Do use eye, hand, face, arm, leg, feet and body protection that is adequate to protect
against flying debris, forcibly ejected work pieces, broken abrasive belts, etc.
Do train operators and others in safe operating practices.
Post these or equivalent instructions such they are available for ready operator
reference.
Burr King Manufacturing can help you with problem solutions, and/or answers to your questions. Please call
your Burr King distributor first. If you can not reach satisfactory conclusion please call the Burr King factory,
telephone 1-660-438-8998.