Aiwa CDC-MP3 YU - Manual (Page 20)

tousi-E-20
19
ENGLISH
Setting up the remote control unit
Replacing the battery
1
Pull out the battery holder, gripping the
claw
B while pressing the groove A to
the right to remove the lithium battery.
2
Install a new lithium battery with the +
side facing upward in the battery holder.
3
Push the battery holder into the remote
control unit until it clicks.
CAUTION
• Keep the lithium battery out of the reach of
children. If swallowed, consult a physician
immediately.
• To prevent a short circuit, never pinch the battery
with pliers, etc.
Steering-wheel-mounted
remote control unit
Lithium battery
(CR2025)
Battery holder
Gap
Steering wheel
Gap
Steering wheel
Gap
Installing the remote control unit
Installation in a vehicle with left-hand drive
1
Attach the belt d to the inner belt
holder e .
Note
If the inner belt holder e does not fit the
steering wheel, attach the cushion c to the
belt holder as illustrated.
Large steering wheel
Small steering wheel
STEERING-WHEEL-MOUNTED REMOTE
CONTROL UNIT
01_CDCMP3(YU)E 00.11.22, 11:40 AM 20