Bodyline Products International 216FD-V - Manual (Page 41)

41 AXIS 216FD/FD-V - System Options
Use NAT traversal when your AXIS 216FD/FD-V/MFD/MFD-V is located on an intranet
(LAN) and you wish to make it available from the other (WAN) side of a NAT router. With
NAT traversal properly configured, all HTTP traffic to an external HTTP port in the NAT
router will be forwarded to the camera.
LAN (intranet) WAN (internet)
Broadband
(NAT)
router
ISP
Notes:
• For NAT traversal to work, this must also be supported by the broadband router.
• The broadband router has many different names: “NAT router”, “Network router“, Internet Gateway”,
“Broadband sharing device” or “Home firewall” but the essential purpose of the device is the same.
Enable/Disable - When enabled, the AXIS 216FD/FD-V/MFD/MFD-V will attempt to
configure port mapping in a NAT router on your network, using UPnP™. Note that UPnP™
must be enabled in the camera (see System Options > Network > UPnP).
Use manually selected NAT router - Select this option to manually select a NAT router
and enter the IP address for the router in the field provided.
If a router is not manually specified, the AXIS 216FD/FD-V/MFD/MFD-V will
automatically search for NAT routers on your network. If more than one router is found,
the default router will be selected.
Alternative HTTP port - Select this option to manually define an external HTTP port. Enter
the port number in the field provided. If no port is entered here a port number will
automatically be selected when NAT traversal is enabled.
Notes:
• An alternative HTTP port can be used/be active even if NAT traversal is disabled. This is useful if e.g. your NAT
router does not support UPnP and you need to manually configure port forwarding in the NAT router.
• If you attempt to manually enter a port that is already in use, another available port will automatically be
selected.
• When the port is selected automatically it will be displayed in this field. This can be changed by entering a
new port number and clicking Save.
FTP
The FTP server running in the AXIS 216FD/FD-V/MFD/MFD-V enables the upload of e.g.
new firmware, user applications, etc. Check the box to enable the service.