beautypg.com

Installation procedure accessories – Kenwood DDX8026BT User Manual

Page 2

background image

2

DNX SERIES/ DDX SERIES

Installation Procedure

Accessories

1. To prevent short circuits, remove the key

from the ignition and disconnect the

-

terminal of the battery.

2. Make the proper input and output wire

connections for each unit.

3. Connect the wire on the wiring harness.
4. Take Connector B on the wiring harness

and connect it to the speaker connector in
your vehicle.

5. Take Connector A on the wiring harness

and connect it to the external power
connector on your vehicle.

6. Connect the wiring harness connector to

the unit.

7. Install the unit in your car.
8. Reconnect the

- terminal of the battery.

9. Press the reset button.
10. Perform the Initial Setup. (Refer to the

Instruction Manual.)

2WARNING

• If you connect the ignition wire (red) and the

battery wire (yellow) to the car chassis (ground),
you may cause a short circuit, that in turn may
start a fire. Always connect those wires to the
power source running through the fuse box.

• Do not cut out the fuse from the ignition wire

(red) and the battery wire (yellow). The power
supply must be connected to the wires via the
fuse.

Acquiring GPS Signals

The first time you turn on DNX9260BT, you
must wait while the system acquires satellite
signals for the first time. This process could
take up to several minutes. Make sure your
vehicle is outdoors in an open area away from
tall buildings and trees for fastest acquisition.
After the system acquires satellites for the
first time, it will acquire satellites quickly each
time thereafter.

About the Front Panel

When removing the product from the
box or installing it, the front panel may be
positioned at the angle shown in (Fig. 1). This

1

..........1

2

..........1

3

..........1

4

..........1

5

..........2

6

..........1

7

DNX9260BT only

..........1

8

DNX9260BT only

..........1

9

..........1

0

DNX9260BT only

..........1

!

..........1

$AKPFD